DIY Audio Projects Forum
http://www.diyaudioprojects.com/Forum/

How to build odd-shaped speaker cabinet (without CNC)
http://www.diyaudioprojects.com/Forum/viewtopic.php?f=11&t=6849
Page 1 of 1

Author:  stecco70 [ 08 Jul 2020, 03:28 ]
Post subject:  How to build odd-shaped speaker cabinet (without CNC)

Hi,
I would like to build a speaker cabinet with an original design (e.g. torqued, double-triangle (see the very-draft picture), etc) but I don't have a CNC.
Any ideas/examples on how to do the wood-work?

Thanks a lot

Author:  jororaitchev [ 08 Jul 2020, 05:25 ]
Post subject:  Re: How to build odd-shaped speaker cabinet (without CNC)

Such a construction will create very big problems with the sound!
It is good to read the basic rules when designing cabinets / including the parameters of the speakers /.
P.S.
You can get an idea at this address:
viewtopic.php?f=11&t=5755
Joro

Author:  AudioStile [ 09 Jul 2020, 04:04 ]
Post subject:  Re: How to build odd-shaped speaker cabinet (without CNC)

Just for the wood-working part (not the project which of course must be the 1st thing):
A 'simple' way is to cut stripes fo MDF and glue them together one on top of the other.
If glued properly and pressed it will be VERY resistant (more then the actual MDF)...
An example can be found in this YT video: https://www.youtube.com/watch?v=1qTWq2tNcyY&t=68s

It also includes some tricks for veneering
I made these:
Attachment:
Enjoy_resized_small.jpg

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/