DIY Audio Projects Forum
http://www.diyaudioprojects.com/Forum/

Turntable Shelves
http://www.diyaudioprojects.com/Forum/viewtopic.php?f=12&t=4235
Page 1 of 1

Author:  gofar99 [ 19 Jan 2013, 20:26 ]
Post subject:  Turntable Shelves

Hi, Not sure where to put this one. I finally got tired of bumping into things that turntables were placed on and causing them to skip. So I built shelves for them. I use track brackets fastened into the studs in the wall. The wall itself is brick on the outside and really strong. An earthquake might cause a skip but nothing less. The shelf brackets were fastened to the bottom of the shelves to prevent movement. The shelves are 3/4 inch MDF with a brace on the front nose section for added strength. The lower TT is a Sota Moonbeam with a Rega arm and Benz Micro LOMC. The upper shelf is the TT I made from a Dual 701 (used only the motor, platter and PS) with an Origin Live arm and a Dynavector 10X5 HOMC. Both cartridges have been retipped by Soundsmith with ruby cantilevers and line contact diamonds. The TTs work great in the new location and while I thought the upper one would be hard to use, it is not. Being just below eye level makes stylus placement a snap.

Good Listening
Bruce

Attachment:
System 19Jan2013.jpg

Attachment:
Phono Shelves 19 Jan 2013.jpg

Author:  Gio [ 22 Jan 2013, 20:45 ]
Post subject:  Re: Turntable Shelves

Looks great Bruce. Always best to have the turntable suspended.

Cheers

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/