NEW Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

FAQ

It is currently 22 Jan 2021, 08:28

Board index » DIY Forums » Audio Sources and Signal Processing

All times are UTC - 6 hours [ DST ]

jfet phono preamp

Page 1 of 1

[ 3 posts ]

Print view

Previous topic | Next topic

Author

Message

silenzio

Post subject: jfet phono preamp

Posted: 26 Mar 2014, 07:29

Joined: 26 Mar 2014, 07:00
Posts: 1

merging two schemes I got a lot of high-quality phono preamp, you can play with resistance at the entrances transistors 1M-decreasing gain.
You can change coupling capacitors ... I have not changed anything from the scheme

However, Enjoy

This post has a file attachment. Please login or register to access it. Only Registered Members may view attached files.

Top

mwhouston

Post subject: Re: jfet phono preamp

Posted: 27 Mar 2014, 06:08

Project Author

Joined: 06 Jun 2008, 18:23
Posts: 5318
Location: Australia

The Le Pacific is a simple and quite good cct. to build and enjoy. Take a look at what Boozhound labs did with it. I think they have improved it. Also with this cct. try adding just 50ohms from source to ground.

_________________
Projects: "Sortilege" - 180W Tripath Class D Mundorf upgrade amp | “Mantra” - tube MM phono preamp | "Carbon” - MM phono preamp | 180W RAW Class D amp |

Top

dantakayama

Post subject: Re: jfet phono preamp

Posted: 02 Nov 2014, 07:53

Joined: 02 Nov 2014, 07:09
Posts: 2

silenzio wrote:

HI,
I'm fairly new to DIY Audio.
I just built LDR based preamp using Tortuga board, which is a volume control unit and nothing more. Then I needed a phone stage, so I built one from BoozHound Lab. But I have a very little volume with this setup. My volume control on Tortuga is all the way up but I only get a quiet listening level. Any body out there with any suggestions?

By the way, I'm getting all your intention for showing 3 pictures; the 3rd picture shows 2 JFETs vs 4 JFETs in fixtures 1 & 2. Am I seeing correct? Are you getting more gain at output? Please excuse my ignorance in electronics; I'm learning slowly @ age 63.

Daniel

Top

Page 1 of 1

[ 3 posts ]

Board index » DIY Forums » Audio Sources and Signal Processing

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum