DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 22 Jan 2021, 08:11

Board index » DIY Forums » Audio Sources and Signal Processing

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
milanmarkovic
PostPosted: 29 Mar 2015, 12:55 
Offline

Joined: 29 Mar 2015, 12:53
Posts: 1
Hello!
I want to replace my car cd player with mobile phone.
I dont have enough space for both so i want to connect mobile phone directly to speakers via custom amplifier and use phone navigation and phone mp3 player.
I have four speaker connections on car audio connector. front (left,right) and rear (left,right). i think that car audio system have embedded filters for
bass and tweeters after cd player connection.
I could make custom amplifier with two IC TDA1553q but i need to split headphone output signal from two to four channels.
Should i connect directly splited signal to tda1553 input or i need to amplify little that signal? How to avoid distortion?
Do you have some suggestions how to make this possible?
Thanks very much!
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » DIY Forums » Audio Sources and Signal Processing

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy