| DIY Audio Projects Forum http://www.diyaudioprojects.com/Forum/ |
|
| Question about Lenco http://www.diyaudioprojects.com/Forum/viewtopic.php?f=12&t=6597 |
Page 1 of 1 |
| Author: | andreidaniel [ 08 Sep 2019, 16:07 ] |
| Post subject: | Question about Lenco |
Hello everybody! I have been reading about Lenco turntables and being a Swiss trademark I heard that was very good. The problems that I found were: 1) why they used those V-blocks instead of pin pivots 2) why most of their tonearms were broken near counter weight? why they used an arm formed by two pieces of metal instead of a single piece of arm? 3) why was used a second counter weight? |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|