DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 01 Dec 2020, 01:12

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 19 May 2020, 18:07 
Offline

Joined: 18 May 2020, 17:10
Posts: 6
Hello all,

Hidden mains wiring is twin and earth single core, the best one for audio use is 1.5 mm/2 which is 1.8mm diameter
It'll take 15 amps at 240 volts errr that's a whole lot of Watts

I didn't believe it either, until I tried and laughed my socks off

Cheers - J


Top
 Profile  
 
PostPosted: 20 May 2020, 15:46 
Offline
Project Author
User avatar

Joined: 04 Jun 2008, 20:59
Posts: 4285
Location: Arizona, USA
Hi, I'm sure this will start a row with some folks, but I personally have not found expensive botique cables any better than lots of low cost cables. Not the 10 cents per foot big box store stuff though. Another "cool" cable posted a while back on the web was made from the 3 wire outdoor 40 foot extension cables from Walmart. I use several types, but mostly 14 gage audio cable rated for in wall use. My system is definitly high end but I figure if you pay more than say $3-5 per meter for cables you are making someone else very happy and taking a ding on your bank account. :eek:

Good listening
Bruce

_________________
Some of my DIY Tube Amplifier Projects:


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy