DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 26 Jan 2021, 23:54

All times are UTC - 6 hours [ DST ]

Post new topic Reply to topic  [ 11 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: 25 Jul 2014, 00:40 

Joined: 09 Oct 2012, 19:43
Posts: 363
Location: Vancouver Canada
I knew i could count on you to love the beauty of it. I have had it for so long and never touched anything cause i just couldn't bring myself to destroy any part of it. The cab is in little worst condition than the pic lets on. Mostly on the top were "stuff" gets placed but i love it anyways. I will say nowhere on it is there any big gouges or dents or chipped edges so worth some TLC. I like your suggestion of using Murphy's Oil Soap. Thank you. I'll look it up and see who has it. When i get more time i will pull the chassis out and make a parts list of caps etc first. The pot will need cleaning. Oil the joints. It looks to be modified at one point but i can't be sure. Maybe it is stock. On the front panel, center of controls there is a toggle sw. An old brass short toggle with the knob on the end. Even if it is a mode, it to, is old. There was a board connecting the right and left set of legs at the bottom of the unit which broke off but a clean break and i have the piece so it will be kept but may not go back in as it is good shoe place. lol

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 11 posts ]  Go to page Previous  1, 2

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© - Terms of Service - Privacy Policy