DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 16 Oct 2019, 14:17

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 07 Oct 2019, 13:49 
Offline

Joined: 07 Oct 2019, 13:19
Posts: 1
Hi all,

I just discovered this forum, and it seems that the following may be of interest for you:

In a two-year project of mine, I did a web research about tube spice models, analysed and compared them, and then merged the best ideas (plus some own) to a new set of generic tube spice models. This models containes the following features:
- the initial velocity current for the control grid
- accurate grid currents, especially for triodes
- no separate model necessary for pentodes connected as triodes
- secondary emission effect is also possible to be described

Currently under development is the enhancement, that my tube models will also work in inverse mode (=control grid will be the output, while the signal is modulated with the (high negative) plate from the backside! ;)

So, if interrested in my spice models, have a visit to:
http://adrianimmler.simplesite.com

Up to know, I have fitted about 2 dozens of vacuum diodes, triodes, tetrodes and pentodes. The fit quality of all fitted tubes is shown with detailed diagrams.

All the best, Adrian


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: Google Adsense [Bot], oloppolo and 17 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy